研究者業績
基本情報
- 所属
- 国立研究開発法人宇宙航空研究開発機構 宇宙科学研究所 学際科学研究系 教授東京大学 大学院工学系研究科 化学システム工学専攻 教授横浜国立大学 総合学術高等研究院 リスク共生社会創造センター 客員教授相模女子大学 客員教授
- 学位
- 博士(工学)(東京大学)
- J-GLOBAL ID
- 200901019157833600
- researchmap会員ID
- 5000019460
- 外部リンク
研究キーワード
12経歴
14-
2024年4月 - 現在
-
2023年4月 - 現在
-
2023年4月 - 現在
-
2022年12月 - 現在
-
2022年8月 - 現在
受賞
10主要な論文
71-
Science and Technology of Energetic Materials : journal of the Japan Explosive Society 73(5) 147-152 2012年12月31日 査読有り筆頭著者
-
航空宇宙技術(Web) 9 15-21 2010年 査読有り筆頭著者The educational hybrid-rocket was successfully launched and it also landed within the predicted area. Aerodynamic characteristics of the rocket designed by students of Tsukuba University were evaluated by the wind tunnel testing with the support of Tokai University. The flight path affected by the environmental condition, especially wind direction and velocity, was simulated with the original calculation program. The altitude of the rocket was measured with the optical equipment and the apex was 123 m although the calculation indicated 198 m. We expected that the insufficient filling or the volatilization of Nitrous oxide as an oxidizer led to this result. And then, the apex was verified with a function of the oxidizer filling ratio. The results showed that 81.2 % of the oxidizer volume in comparison with the firing test condition was accumulated in the tank at the launch.
-
Science and Technology of Energetic Materials : journal of the Japan Explosive Society 67(6) 187-192 2006年12月31日 査読有り筆頭著者
-
火薬学会誌 = Journal of the Japan Explosives Society : explosion, explosives and pyrotechnics 60(2) 83-90 1999年4月30日 査読有り筆頭著者
MISC
130-
日本燃焼学会誌 = Journal of the Combustion Society of Japan 65(214) 220-223 2023年11月
講演・口頭発表等
241-
Proc. The 16th International Symposium on Fireworks 2017年4月
-
ロボティクス・メカトロニクス講演会講演概要集 2017年 一般社団法人 日本機械学会<p>In recent years, demand for launch of the rockets has increased from space development. Although the solid propellant rockets relatively reasonable, it is difficult to safely manufacture a large of solid propellant, and the manufacturing process is non-constant. Therefore, we consider it is more reasonable if it is possible to manufacture the solid propellant safely and continuously. We focused on the movements to mix of the intestinal tract. We have developed a peristaltic pump that based on bowel peristaltic using straight-fiber-type artificial muscle. In this paper, We developed an inter-units heating device as a heating function for realizing a continuous mixing and Transport process using a peristaltic pump, and measured heating performance of inter-units heating device and show its usefulness.</p>
-
ロボティクス・メカトロニクス講演会講演概要集 2017年 一般社団法人 日本機械学会<p>In recent years, the demand for rocket launching has increased due to the development of space technology. However, using inexpensive rockets is not always possible. Although the cost of solid-propellant rockets is relatively reasonable, safely manufacturing a large amount of solid propellant is difficult, and the manufacturing process is disjointed. Therefore, safe and continues manufacturing of solid propellant is necessary. On the basis of the movements of the intestinal tract, we proposed that the movements required for transport and mixing of solid propellants are possible to achieve without the application of a large shear force. The peristaltic motion enables not only the mixing but also conveying even high viscosity slurry. By mimicking these intestinal movements, we have considered and developed the peristaltic pumping by driven artificial muscle as one of the candidates for the continuous and safety mixer. In this research, the mixing completeness of the composite solid propellant slurry by the peristaltic pumping mixer was estimated. The result showed that the mixer we proposed could mix the propellant slurry. In the propellant samples, these variances were sufficiently small.</p>
-
Proceedings of the International Astronautical Congress, IAC 2017年
-
Proc. The 8th Asian Joint Conference on Propulsion and Power (AJCPP) 2016年3月 招待有り
-
Proceedings of the International Astronautical Congress, IAC 2016年
-
航空原動機・宇宙推進講演会講演論文集(CD-ROM) 2016年
-
平成27年度宇宙輸送シンポジウム: 講演集録 = Proceedings of Space Transportation Symposium FY2015 2016年1月 宇宙航空研究開発機構宇宙科学研究所(JAXA)(ISAS)平成27年度宇宙輸送シンポジウム(2016年1月14日-15日. 宇宙航空研究開発機構宇宙科学研究所(JAXA)(ISAS)), 相模原市, 神奈川県資料番号: SA6000050034レポート番号: STCP-2015-035 Space Transportation Symposium FY2015 (January 14-15, 2016. Institute of Space and Astronautical Science, Japan Aerospace Exploration Agency (JAXA)(ISAS)), Sagamihara, Kanagawa Japan
-
IEEE International Conference on Intelligent Robots and Systems 2015年12月11日 IEEE
-
Proc. 30th International Symposium on Space Technology and Science (ISTS) 2015年7月
-
Proc. 30th International Symposium on Space Technology and Science (ISTS) 2015年7月
担当経験のある科目(授業)
2-
宇宙推進燃料工学 (東京大学工学系研究科化学システム工学専攻)
-
エネルギー物質化学特論 (東京大学工学系研究科化学システム工学専攻)
Works(作品等)
3共同研究・競争的資金等の研究課題
11-
日本学術振興会 科学研究費助成事業 2023年11月 - 2030年3月
-
日本学術振興会 科学研究費助成事業 2023年4月 - 2028年3月
-
日本学術振興会 科学研究費助成事業 特別推進研究 2019年4月 - 2024年3月
-
日本学術振興会 科学研究費助成事業 挑戦的萌芽研究 2015年4月 - 2017年3月
-
日本学術振興会 科学研究費助成事業 基盤研究(A) 2012年4月 - 2017年3月